| The national measurement standards at CEM and their role in MRA and EMRP projects |
58 |
| New architectures for high-performance arbitrary waveform generators (AWG) |
94 |
| Measurement of frequency dependences of low-value four-terminal resistance standards |
54 |
| Calibration system for electric charge at the Centro Español de Metrología |
98 |
| Quasi-analytical design of a square helmholtz coil with finite cross-sectional area as a magnetic flux density standard |
91 |
| Universal laboratory measurement system for evaluation of the impedance spectroscopy method based on multi-harmonic excitation signal |
62 |
| Metal plate thickness classification in eddy current testing using support vector machine |
77 |
| ECT characterization of a linear defect from multiple angle measurements |
84 |
| Long-term monitoring of photovoltaic plants |
63 |
| Design and measurement of the nH level mutual inductor |
69 |
| Multipole-field correction of stretched-wire measurements of the gradient in accelerator magnets |
61 |
| Interlaboratory comparison pf microwave power measurement using type N coaxial line |
77 |
| Study and characterization of a microcalorimeter thermostat |
70 |
| Water estimation in sugar cane using microwaves signal |
132 |
| Water fraction measurement using a RF resonant cavity sensor |
171 |
| Characterization of the propagation channel on board trains |
64 |
| Experimental set-up for the validation of numerical methods in electromagnetic dosimetry |
75 |
| Calibration of magnetic field meters up to 50 kHz at CMI |
92 |
| A study on the potential use of commercial digital two-phase generators in impedance comparison bridges |
85 |
| Extending the scale of inductance using 1:1 comparator bridge |
61 |
| Thermal AC voltage standards with calculable AC-DC transfer difference in frequency range from 10 kHz to 1 MHz |
73 |
| Development of a system for the accurate measurement of power with distorted waveforms |
70 |
| Measurement of amplitude ratio and phase shift between sinusoidal voltages with superimposed gaussian noise |
60 |
| Good practice guide for calibrating a hydrophone “in situ” |
73 |
| Calibration of low-current meters at nA level with the capacitance-charging method |
69 |
| Traceability for aerosol electrometer in the fA range |
65 |
| Thermal converter level dependence determination by digital sampling |
56 |
| Exhaled breath alcohol - quality assurance in the field of legal metrology |
61 |
| Electromechanical characterizations of MEMS based energy harvesters by harmonic sampling analysis method |
60 |
| Phase error in current transformers with nanocrystalline alloys core |
75 |
| Estimation of the amplitude quotient of signals with common frequency |
82 |
| Ultrasonic time of flight estimation for wind speed measurement based on time-frequency domain using STFT |
96 |
| Impedance estimation of a vibrating wire viscosity sensor using multi-harmonic signals |
95 |
| Operators to calculate the derivative of digital signals |
86 |
| Parameter extraction in multi step exponential signal |
64 |
| Contribution of the spectral interference from the image component to the discrete spectrum of a sine-wave |
80 |
| Transient reduction in pulse-based impedance measurements |
51 |
| Average value evaluation of the distorted pulse signal |
96 |
| Crack size identification and localization using ultrasonic sensors with stationary wavelet transform and hilbert transform |
101 |
| Time domain processing of pulsed differential eddy currents testing signals |
62 |
| On the use of complex excitation sequences for eddy current testing |
58 |
| The analysis of exponential signals by maximum likelihood estimation |
60 |
| PSD estimation in Cognitive Radio systems: a performance analysis |
63 |
| On compressed sensing and super-resolution in DFT-based spectral analysis |
86 |
| The improvement of compensating current generation algorithms in active power filtering |
57 |
| Contactless measurements for on line quality monitoring in rubber extrusion processes |
74 |
| Analysis of NetCDF-4 and HDF-5 scientific file formats for the data archiving of ITER fast plant system controller prototype |
72 |
| A portable, wireless and low cost solution for acquisition signal studies: a case for EMG signal |
80 |
| Geometric feature extraction for precise measurements in intramedullary nail images |
90 |
| Wireless intelligent systems for biosignals monitoring using low cost devices |
64 |
| Uncertainty factors in time-interval measurements in ballistocardiography |
62 |
| Electrical Impedance Spectroscopy cell monitoring in a miniaturized bioreactor |
112 |
| Upon te influence of the real value of human body capacitance in ESD immunity tests |
69 |
| Monitoring cell monolayers during electroporation: Electrical impedance spectroscopy measurements |
69 |
| Noninvasive system of transcranial magnetic stimulation focused and deep |
91 |
| Model of errors caused by discrepancies of input channels in multiresolution ADC |
76 |
| A method for restraining electromagnetic interference of electricity meter by means of pulse width testing circuit |
53 |
| Assessment of the immunity to radiated disturbances of an FPAA-based front-end device for ECG signal monitoring |
64 |
| A smart measurement network for optimization of electrical grid operation |
86 |
| Programmable power spectral density noise source |
82 |
| Evaluation of the uncertainty of calibration the of three phase high precision comparator of the electrical power |
64 |
| Experimental evaluation of potential distribution in a grounding grid subjected to impulse current |
66 |
| A method for estimating state of charge in energy-aware wireless sensor nodes |
69 |
| Multi-channel system for remote power quality monitoring of electricity supplied by public distribution networks |
76 |
| Low power and high efficency energy acquisition systems for volcano monitoring |
69 |
| Measurement technique for online EV battery state of life monitoring |
90 |
| A real-time compensation method for MV voltage transducer for power quality analysis |
65 |
| Testing of high current transformer by non-uniform equivalent magnetomotive force method |
84 |
| The evolution of electrical energy measurement in Brazil |
85 |
| Detection and characterization of amplitude defects using spectral kurtosis |
90 |
| Virtual instrument for power quality research |
80 |
| Characterised measuring system for PQ measurements on the MV grid |
63 |
| Detection and characterization of oscillatory transient using Spectral Kurtosis |
91 |
| Architecture of the multi-tap-delay-line time-interval measurement module implemented in FPGA device |
162 |
| Influence of GPS measurements quality to NTP time-keeping |
79 |
| Uncertainty to harmonic measurements with DFT techniques |
66 |
| IEEE1588 V2 clock distribution in FlexRIO devices: clock drift measurement |
74 |
| Double squirrel cage induction motors: a new approach to detect rotor bar failures |
62 |
| An FPGA-based system for real-time monitoring of voltage harmonics |
68 |
| Using an IEEE1149.1 test bus for fault diagnosis of analog parts of electronic embedded Systems |
68 |
| Automatic and systematic control of experimental data measurements on ASICs |
105 |
| DSP based data acquisition system with on-board processing |
64 |
| Impedance simulator for automatic calibration of LCR meters: proof-of-principle experiment |
88 |
| Power profile generator for the test of microgrid measurement and control systems |
62 |
| Low-frequency noise measurements in silicon power MOSFETs as a tool to experimentally investigate the defectiveness of the gate oxide |
69 |
| A new capacitance-to-digital convertor suitable for human proximity sensing |
74 |
| Design and implementation of an automatic measurement system for the characterization of power MOSFETs |
61 |
| Application of intelligent instruments for the monitoring of thrust reverse noise at airports |
60 |
| Digital pulse determination of high-current shunts frequency response |
66 |
| A robust and non-invasive heart-rate monitoring system |
58 |
| Data acquisition for green roof |
74 |
| Carbon/polymer hybrid bio-sensors for neurotransmitters analysis |
70 |
| Investigation of planar coil for eddy current conductivity measurements in wide frequency range |
113 |
| A novel capacitance-to-digital converter for capacitive sensors with AC excitation |
54 |
| Development of electrochemical nano-biosensors with distributed metal particles |
63 |
| Landslide transducer based on amorphous wire strain gauges |
61 |
| Low cost smart sensors for an intelligent home |
88 |
| A magnetic field probe for hostile environments |
45 |
| A numerical method of correcting the influence of the additional quantities for nonselective sensors |
63 |
| Study of a hall effect brake wear sensor using finite element modelling and analysis |
71 |
| Method for forming a magnetic field of arbitrary shape from an established template |
71 |
| Modeling and simulation of a wheatstone bridge pressure sensor in high temperature with VHDL-AMS |
82 |
| Measurement of landslide displacement and orientation using strain gauges based on amorphous magnetic microwires |
72 |
| Improving the convergence of gene expression programming in impedance spectroscopy |
85 |
| Threshold estimation for impedance spectroscopy in equivalent circuit identification |
60 |
| A new peak detector based on usage of CCCIIs |
50 |
| Identification of wire network topology using impedance spectroscopy |
74 |
| Modelling the non-stationary behaviour of time-varying bioimpedance |
62 |
| Advanced parameter measurement of energy storage systems for smart grids application |
67 |
| Voltage source inverters: an easy approach for fast fault detection |
58 |
| Design and implementation of a hybrid MPPT technique based on the scan of the power vs voltage input characteristic of the inverter |
84 |
| A smart current control of a measurement station for superconducting cable test |
93 |
| Cloud nowcasting: motion analysis of all-sky images using velocity fields |
73 |
| Time-synchronous sampling in wireless sensor networks |
59 |
| Double quasi - balanced meter for measurement of inductor quality factor |
93 |
| Automated quasi-balancing in virtual quasi-balanced circuit designed to capacitance measurements |
63 |
| Taking advantage of machine learning and pattern recognition in acoustic measurements |
82 |
| Precision timing in TDMA-based Wireless Sensor Network through IEEE 1588 standard |
80 |
| Smart postural monitor for elderly people |
71 |
| Synchronization of DLMS/COSEM sensor nodes |
136 |
| Experimental results on magnetic cores for magnetic induction-based energy harvesting |
80 |
| Measuring system and power management of the Guanay II AUV |
71 |
| pH sensor calibration procedure |
93 |
| Improving the single point calibration technique in direct sensor-to-microcontroller interface by increasing nonlinearity |
83 |
| Novel time-interleaved variable center-frequency, single-bit A/D and D/A sigma-delta modulator topologies |
56 |
| The matlab toolbox for simulation analysis and design support of new adaptive sub-ranging A/D converters |
53 |
| A frequency independent method for adaptive correction of time interleaved analog to digital converters |
61 |
| Low-cost multi-channel synchronous data acquisition system based on compressive sampling approach |
66 |
| Defining frequency domain performance of analog-to-information converters |
109 |
| Decimator filter based on B-splines |
92 |
| From system design to clock skew impact study in parallel sigma delta modulators using frequency band decomposition |
81 |
| NFC RF analog challenge and enhanced high speed transmitter design |
65 |
| Design of seismic acquisition system for volcanology |
59 |
| A novel blind adaptive correction algorithm for 2-channel time-interleaved ADCs |
139 |
| A folding ADC based on switched capacitor circuits in 350 nm CMOS |
93 |
| User-friendly software tool for advanced ADC testing |
89 |
| Assessment of the uncertainty associated with synchronization error in analog to digital conversion with dither and CAV |
68 |
| Ultrapure sinewave generation by combining Josephson systems |
371 |
| Hypothesis test on the ratio between two measurement uncertainties |
76 |
| Improving the result of the histogram test using a fast sine fit algorithm |
102 |
| New effective architectures and conversion algorithms for adaptive sub-ranging A/D converters |
69 |
| Thermocouple dynamic errors correction for instantaneous temperature measurements in induction heating |
68 |
| Linearization of A/D converters using dither |
66 |